SYNTAXFor Windows, the manual ought to describe the syntax of, and give examples for, the command line for
a) paths without blanks,
b) paths with blanks,
c) commands with gtp,
d) commands without gtp,
e) commands with -model,
f) commands without -model,
g) commands with -config,
h) commands without -config
etc. as far as such variants are possible. Currently, I guess that the following is an example with a correct syntax but I cannot be sure due to bugs:
Code:
C:\katago\katago.exe gtp -model C:\katago\b18.bin.gz -config C:\katago\gtp_custom.cfg
PATH TO KATAGO MODEL FILEKaTrain 1.7.2.0 for Windows writes in General & Engine Settings, for example,
Code:
Path to KataGo model file = C:/baduk/lizzie/KataGo40b.gz
In Windows, this is misleading as it suggests an apparently wrong syntax for the command line. Windows paths use backslashes instead of slashes. Therefore, the following with backslashes should be written:
Code:
Path to KataGo model file = C:\baduk\lizzie\KataGo40b.gz
BUGI use Windows 11 Pro 64b, Baduk AI Megapack 4_18_0 x64 and its KaTrain 1.7.2.0. In Lizzie, the following command line works:
Code:
C:\katago\katago.exe gtp -model C:\katago\b18.bin.gz -config C:\katago\gtp_custom.cfg
In KaTrain, this command line does not work, although I guess that it has a correct syntax. For details, see
https://www.lifein19x19.com/viewtopic.p ... 63#p278163https://www.lifein19x19.com/viewtopic.p ... 84#p278184https://www.lifein19x19.com/viewtopic.p ... 87#p278187